Remote Control Buttons for LCD TV Functions
1)(STANDBY)
To set the TV to standby mode. To switch the TV set on again, press P
2) Pixel + (only available on certain models/ versions)
Switches the Pixel + demonstration mode on or off.
3) ® IÒ ‡ π †I º Peripheral device buttons
(Refer to “Mode selector” on page 5)
4)QSurround mode
To activate / deactivate the surround sound effect. In stereo, this gives the impression that the speakers are further apart. For models equipped with Virtual Dolby Surround*, you can experience Dolby Surround Pro Logic sound effects.
5)AV
To display Source List to select TV or peripheral equipment connected to TV, AV, REAR/SVHS,
6)hActive control
Optimizes the picture quality depending on the quality of the incoming signal and the ambient light conditions.
7)MENU
To call up or exit the TV menus.
8)Cursor
These 4 buttons are used to navigate around the menus ( ÎïÍÆ ).
9)Volume
To adjust the sound level.
10) Smart picture and sound
Used to access a series of predefined picture and sound settings.
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)
11) 
Screen information
To display/remove the programme number, the time, the sound mode and the time remaining on the timer. Hold down for 5 seconds to permanently display the programme number on the screen.
*Manufactured under license from Dolby Laboratories. “Dolby” and the
4
