Sherwood R-872 manual Using Functions Of Remote Control, Entering a setup code, English

USING FUNCTIONS OF REMOTE CONTROL

•This remote control can control up to 8 different components.

•Before operating audio and video components other than this receiver with using this remote control, the setup code for each component should be entered.

•For system remote control operation, "000" was stored previously in the memory of the device button "CD" for Sherwood CD player, "DVD" for Sherwood DVD player, "AUX" for Sherwood tape deck and "TV" for Sherwood TV respectively as its factory setup code. So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not work.

■Note :

•If the transmission signal which this remote control emits is changed into "RF"(Radio Frequency), this remote control cannot control other audio and video components. (For details, refer to "Changing the transmission signal" on page 29.)

Entering a setup code	4. While "LEARN" is displayed, press the CURSOR
• Setup code entry is the easiest way to program	UP(▲)/DOWN(▼) buttons to select the setup
	code mode ("CODE"), then press the ENTER
this remote control for operating audio and video
	button.
components.
1. Turn on the component you want to operate.
2. Find the setup codes according to the type and
the brand name of your component, referring to
"Setup Code Table" on page 77.

	• Each time the CURSOR UP(▲)/DOWN(▼)
	buttons are pressed, the mode changes as
3. Press and hold down both the ENTER button	follows :
	LEARN RF-IR DELETE MACRO
and the desired one of the DEVICE buttons for	CODE PUNCH
more than 2 seconds.	• Then "PRESET" and 3 digit number are
	displayed.
	• If "PRESET", etc. go off, start again from the
	above step 3.
	5. While "PRESET", etc. are displayed, enter a 3
	digit code and press the ENTER button.

	Example: When entering "001".
• Then "LEARN" is displayed on the LCD screen for
several seconds.	• Then "OK" is displayed on the LCD screen.
	• To be sure that the setup code is correct, press
■Notes :	the POWER ON (or STANDBY) button, aiming
• The AUDIO button is unavailable for the audio	the remote sensor on the component.
components other than this receiver.	• If the setup code is correct, your component will
• During setting operation, to exit from the setting	be turned off.
	• When your component is not turned off, repeat
mode, press any of the DEVICE buttons.
	the above steps 2 to 5, trying entering each code
	for your component until you find one that works.
	• If "NG" is displayed, retry entering the correct
	setup code while "PRESET" and 3 digit number
	are displayed.

ENGLISH

21