Sherwood R-872 Operating a punch-throughfunction, Erasing the programmed punch-throughfunction

Continued

3. While the device is displayed, press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired punch-through device, then press the ENTER button.

•Each time the CURSOR UP(▲)/DOWN(▼) buttons are pressed, depending on the selected punch-through mode, punch-through devices and the one punch-through deleting mode ("DELETE") are selected as follows :

•In case of the volume punch-through,

→ AUDIO DELETE TV ←

• In case of the transport punch-through,

→ CD DELETE DVD VCR AUX ←

• In case of the channel punch-through,

→ TV DELETE SAT CABLE VCR ←

•Then "OK" is displayed and the current punch- through mode is displayed.

4. While the punch-through mode is displayed, repeat the above steps 2 and 3 to program other punch-through function under the same master device mode.

5. To program punch-through functions under other master device mode, repeat the above steps 1 to 4.

Operating a punch-through function

•While this remote control is set to control a master device, aim the remote control at the REMOTE SENSOR of the punch-through device and press the desired button of the programmed punch-through controls.

Example: When pressing "PLAY (▶)" button.

•Then the punch-through device is displayed on the LCD screen.

Erasing the programmed punch-through function

1. Perform the steps 3 and 4 in "Entering a setup code" procedure on page 21 to select a master device and the punch-through mode ("PUNCH").

•Then "VOL" is displayed on the LCD screen for several seconds.

2. While "VOL" is displayed, press the CURSOR UP(▲)/DOWN(▼) buttons to select the punch- through mode to be erased, then press the ENTER button.

•Each time the CURSOR UP(▲)/DOWN(▼) buttons are pressed, the mode changes as follows:

→VOL DELETE PLAY CH ←

•Then the device is displayed .

27

ENGLISH