Programming a macro function
•The macro function enables you to program a series of button operations(up to 15) on this remote control into a single button.
•You can store up to three separate macro command sequences into "M1", "M2" and "M3" buttons.
1. Perform the steps 3 and 4 in "Entering a setup code" procedure on page 21 to select the macro mode ("MACRO").
•Then "M1" is displayed on the LCD screen for several seconds.
•During macro setting operation, pressing any of the DEVICE buttons cannot exit from the macro mode.
2. While "M1" is displayed, press the CURSOR UP(▲)/DOWN(▼) buttons to select the MACRO button to be programmed into, then press the ENTER button.
•Each time the CURSOR UP(▲)/DOWN(▼) buttons are pressed, "M1", "M2" or "M3" is selected.
•Then "SEL" is flickering.
•If "SEL" goes off, start again from the above step 1.
3. While "SEL" is flickering, press the operation buttons you want to program in order.
Example: When playing a DVD on the DVD player connected to VIDEO 2 jacks of this receiver.
①. Press "AUDIO" button to control this receiver.
②. Press "POWER ON" button to turn this receiver on.
③. Press "VIDEO 2(7)" button to select the desired input source.
④. Press "DVD" button to control the DVD player.
⑤. Press "POWER ON" button to turn the DVD player on.
⑥. Press "PLAY (▶)" button to start playback.
•Each time the operation buttons are pressed, the programmed order is displayed.
4.Press any of the MACRO buttons (M1~M3) to complete the programming.
• Then "OK" is displayed.
■To erase a macro program
•When erasing a macro program, perform the above steps 1, 2 and 4, but ignore the step 3.
■To change a macro program
•When a new macro program is stored into a MACRO button with performing the above steps 1 to 4, the previous macro program is erased from the memory of the MACRO button.
ENGLISH
25
