Continued
When using the buttons on the front panel
1. Press the ROOM 2 button to enter the ROOM 2 mode.
•ROOM 2 ~ is displayed for several seconds.
•When the ROOM 2 setting mode disappears, press the ROOM 2 button again.
2. Select the desired mode while displaying the ROOM 2 setting mode.
• Each time these buttons are pressed, the mode changes as follows :
ROOM 2 ~ | : To turn on or off the ROOM 2 |
(ROOM 2 mode) | function. |
INPUT ~ | : To select the desired ROOM 2 |
(ROOM 2 input) | source. |
VOLUME ~ : To adjust the volume on the (ROOM 2 volume) power amplifier assigned to ROOM 2.
■Note :
•When the ROOM 2 mode is set to OFF, the ROOM 2 input and the ROOM 2 volume cannot be selected.
3. Set the selected mode as desired.
■When selecting the ROOM 2 mode. |
| ||
ON : To turn on the ROOM 2 function. |
| ||
(" | " lights up.) |
|
|
OFF : To turn it off. (" | " or " | " | |
goes off depending on the AMP ASSIGN setting.)
■When selecting the ROOM 2 input.
•You can select the desired among MAIN source, TUNER, CD, AUX, TAPE, VIDEO 1 ~ VIDEO 4 as a ROOM 2 source.
■When selecting the ROOM 2 volume.
•You can adjust the volume on the power amplifier assigned to "BACK ← → ROOM 2" or "ROOM 2" when the ROOM 2 speaker terminals are connected to the speakers in a different room. (For details, refer to "When selecting the AMP ASSIGN" on page 52.)
4.Start play on the component related to the ROOM 2 source.
ENGLISH
■Notes:
•When the EXTERNAL IN is selected as a main input, if the MAIN source is selected as a ROOM 2 input, no audio signal can be heard in the different room (ROOM 2).
•Even when this receiver enters the standby mode, in such a case that " 
" lights up still and the POWER ON/STANDBY button lights up blue as it does in the operating mode, meaning only the ROOM 2 circuitry operates, the ROOM 2 source can be played independently.
•When you do not use the ROOM 2 function, turn off the ROOM 2 function to save electricity.
49
