ENGLISH
6. Operate the component using the corresponding function buttons.
• If any of buttons fails to operate as they should, start from the step 1 again to enter the correct setup code.
■Note :
•Manufacturers may use different setup codes for the same product category. For that reason, it is important that you check to see if the code you have entered operates as many controls as possible. If only a few functions operate, check to see if another code will work with more buttons.
7. Repeat the above steps 1 to 6 for each of your other components.
Searching a setup code
•In addition to enter a setup code using "Setup Code Table" on page 77, it is also possible to search through all the codes that are stored in the library of this remote control.
1. Turn on the component you want to operate.
2. Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 21 to select the setup code mode ("CODE").
3. While "PRESET" is displayed, search a setup
code, aiming the remote control at the remote sensor on the component.
•Each time the CURSOR UP(▲)/DOWN(▼) buttons are pressed, the setup code is selected one by one.
•If the selected code is correct, your component will be turned off.
•When your component is not turned off, repeat this step until you find one that works.
4.While "PRESET" is displayed, press the ENTER button to store the setup code.
• Then "OK" is displayed on the LCD screen.
5. Operate the component using the corresponding function buttons.
•If any of buttons fails to operate as they should, start from the step 1 again to find the correct setup code.
6. Repeat the above steps 1 to 5 for each of your other components.
22