Sherwood R-872 manual Changing the transmission signal, When RF is set to, English

Changing the transmission signal

•This remote control can emit not only the infrared beams which the conventional remote control uses but also the RF(Radio Frequency) beams which are stronger than those.

•When you want to control this receiver from longer distance even if there are obstacles such as walls,

furniture, etc. in the way, change the transmission signal into "RF"(Radio Frequency).

■Notes:

•When the RF remote antenna is not connected, remote operation will become unreliable. (For details, refer to "CONNECTING RF REMOTE ANTENNA" on page 14.)

•If the transmission signal mode is set to "RF" (Radio Frequency), this remote control cannot control other audio and video components.

•In this case, to control the component, connect the IR emitter to the IR OUT jack. (For details, refer to "CONNECTING MULTI-ROOM SYSTEM KIT" on page 14.)

1. Press and hold down the ENTER button and the AUDIO button for more than 2 seconds.

• Then "LEARN" is displayed on the LCD screen for several seconds.

■Note:

•During setting operation, to exit from the setting mode, press any of the DEVICE buttons.

2. While "LEARN" is displayed, press the CURSOR UP(▲)/DOWN(▼) buttons to select the transmission signal mode("RF-IR"), then press the ENTER button.

•Then "RF" (or "IR") is displayed.

•If "RF" (or "IR") goes off, start again from the above step 1.

29

3. While "RF" (or "IR") is displayed, press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired transmission signal, then press the ENTER button.

ENGLISH

•Each time the CURSOR UP(▲)/DOWN(▼) buttons are pressed, the mode changes as follows :

"RF" : This remote control emits the RF(Radio Frequency) beams which stronger than the infrared beams.

"IR" : This remote control emits the infrared beams which the conventional remote control uses.

•Then "OK" is displayed.

■When "RF" is set to.

4. To pair up this remote control and the receiver, press the CONTROL DOWN(▼) button and the MEMORY/ENTER button simultaneously on the receiver.

•"RF REMOCON PAIRING MODE" is displayed for several seconds on the display of the receiver.

•If "RF REMOCON PAIRING MODE" goes off, press these buttons again.

5. While "RF REMOCON PAIRING MODE" is displayed, press the ENTER button, aiming at the receiver.

• Then "PAIRING SUCCESS" is displayed.