Philips 32ST220P manual Setting the Remote Control to Work with Other Devices

SETTING THE REMOTE CONTROL TO WORK WITH OTHER DEVICES

	Search Method
	our TV remote can be set to
	Ywork various external devices
	such as VCRs, Cable Boxes,
	Satellite Receivers, DBS, DVD,
	etc. by what is called the search
	method.
	If the “Remote Code” number
	method shown on the previous
	pages did not set your remote to
	work your external device, then
	follow the easy steps listed below.
	Please read steps 1-4 before
	beginning.
	BEGIN
1 Press the POWER button on
	the device your are attempting to
	program to turn it ON.
2	Place the TV/VCR/ACC
	Mode Switch in the proper posi-
	tion.
3 Press the (A/CH) •
	RECORD and the SMART
	SOUND buttons simultaneous-
	ly and hold them down.
4	The device will begin to
	change channels after the
	remote identifies the correct
	code. When the channels start to
	change release the A/CH
	RECORD and SMART SOUND
	buttons. The remote should be
	ready to operate the device.
	STOP
	SMART HELP
	This method can take up to
	two minutes to complete.

Don’t let the device scan up more than five channels. If you do the remote may pass up the right code, and another two minute search cycle will have to be repeated.

If no channel change happens within two minutes, repeat steps 1-4. Should a channel change still not occur, the remote will not work with the desired device.

Satellite Receiver

Cable Converter		070809 06			07
1
					0809
		06		0708
VCR				09
				POWER	4
2	SLEEP
	A/CH	STATUS/EXIT	CC	CLOCK
TV	RECORD			TV/VCR
VCR	1	2		3
ACC				3
	4	5
	7	8		9
	SMART			SMART
		0
	SOUND			PICTURE
	MENU			SURF
3
	VOL			CH
		MUTE

27