Switching on and initial setup
Before you switch on the TV, check that the AC power cord is properly connected. Press . POWER at the right side of the TV, or press . on the remote control.The TV normally takes
InitialI iti l Setupt
|
|
|
|
Select your menu language. |
| English | |
|
|
|
|
|
|
| |
Seleccione el idioma para el menú. |
| Español | |
|
|
|
|
Sélectionnez la langue du menu. |
|
| |
| Français | ||
|
|
|
|
Select | OK OK | MENU |
Skip |
Follow the
Press Í or Æ to select the desired mode for energy saving, then press
OK.
Select “Retail” or “Home” for your location.
Retail | Home |
Select
OK
Select [Retail] if you want backlight to be brighter. Select [Home] to reduce power consumption.
You must set [Home]. Otherwise, personalized picture and sound settings will not be memorized after the unit goes to standby mode.
•Select [Retail], the unit will be set up with predefined setting for retail displays. In this setting, the power consumption may possibly exceed the limited requirement of the ENERGY STAR® qualification.
•Select [Home], the unit will be set to maximize energy efficiency. Picture and sound settings can be adjusted and saved as per your personal preferences.
Press OK to begin [Settings assistant].
Settings assistant helps you customize picture settings. You will see a series of test pictures where the right side and left side differ. Select the side that is most pleasing to you with the Left/ Right keys.
| OK Next | BACK | MENU |
| |||
| Back | Exit | |
|
|
|
|
Press Í or Æ 5 times to select the side of the pictures that is the most pleasing to you. then press OK.
Left side | Right side |
|
|
1/5 Select the picture setting that you prefer.
Select | OK Next | BACK | MENU |
Back | Exit |
Press OK to finish [Settings assistant].
You have set up your viewing preferences.
| OK Store | BACK | MENU |
| |||
| Back | Exit | |
|
|
|
|
Finish the Setup.
Note
•If you are not receiving a signal from your cable service, contact the CATV provider.
•If you press . or MENU during autoprogram, this setting will be canceled.
•The initial autoprogram function can be executed for either [Antenna] or [Cable] only once.When you change the connection (Antenna / Cable), set autoprogram again. (Refer to page 24.)
•If there is no signal input from the antenna terminal and no operation for several seconds after you turn on the TV, [Helpful Hints] appears. Follow the instructions listed on the TV screen.
E n g l i s h
EN 11
