32
Note
You must map the audio in put from the •
connected devi ce to your TV in order to u se
this feature.
Enable remote control pass-through
1 Enable one-touch p lay and one-touch
standby bet ween easylink complia nt
devices by following the i nstructions
in the previous section (see ‘Enabl e or
disable EasyL ink’ on page 31 ).
2 Press ( Home).
3 Press to select a device wi th
HDMI connecto r from your home menu.
4 Press OPTIONS.
5 Press to select [Enable RC pass] and
press OK.
RC pass-through is enabled on the »
selected device.
Note
Easylink comp liant device must be con nected •
to the TV via HDM I connector.
HDMI Device
Amplifier
HDMI
HDMI
2 Press ( Home).
3 Press to select [Setup] > [Sound]
>[TV speakers] > [Auto EasyLink].
The TV speakers are turned off »
automatically when content from an
Easylink compliant system is detected.
4 Pres s to select [Setup] > [Sound]
>[TV speakers] > [On] to d isable
system audio con trol and enable the T V
speakers.
Note
If you select •[TV speaker s] >[O ff], the TV
speakers ar e muted.
Connect an ampli¯ er
An amplifi er such as Home theatre Syste m or
AV receiver can be used to pl ay audio from an
Easylink compl iant device connected to yo ur
TV.
An amplifi er can be connected in the following
different ways :
An amplifi er with only one HDMI outpu t. •
Audio can be played by the a mplifi er
from the device or T V.
Amplifi er with one HDMI input and •
several HDMI ou tputs. Audio can
be played by the amplifi er via HDMI
connector from yo ur device.
HDMI Device
Amplifier
HDMI
SPDIF OUT /
Analogue Audio
HDMI
SPDIF OUT/
Analogue audio
12
EN
Downloaded From TV-Manual.com Manuals