9 Troubleshooting
Television and remote control
The TV does not switch on
•Verify the mains cord connection.
•Verify if the batteries of the remote control are not empty or weak.Verify their + / - orientation.
You can use the keys on the TV to switch the TV on.
•Unplug the mains cord, wait a minute and plug it back in.Try again to switch on.
The TV does not react on the remote control
•Verify if the batteries of the remote control are not empty or weak.Verify their + / - orientation.
•Clean the remote control and TV sensor lens.
The TV switches off and the red light blinks
•Unplug the mains cord, wait a minute and plug it back in.Verify if there is enough space for ventilation. Wait until the TV has cooled down. When the TV does not restart to standby and the blinking occurs again, call our Customer Care.
You forgot your code to unlock Child lock
•See section 5.7.3 Set code / Change code.
Wrong language in the TV menu ?
Follow these steps to change the language.
‡Press Menu on the remote control. ® Use œ to select the last menu line. ÒPress πthree times.
† Press o or œ to select your language. º Press OK.
◊Press Menu to quit the menus.
TV channels
Some TV channels are gone
•Verify if the correct channel list is chosen.
•A channel could be uninstalled in the Rearrange menu.
No digital channels found during installation
•Verify if the TV supports
Picture
The sound is on, but there is no picture
• Verify the contrast or brightness setting in the menu.
The TV picture is poor
•Verify if the antenna is connected properly.
•
•Verify if the correct TV system is chosen in the Manual installation menu.
•If only a certain channel is poor, try to fine tune this channel in the Fine tune menu. See section 6.2.3.
The picture has poor colour
•Verify the colour settings in the Picture menu. Select any of the Smart settings in the Smart settings menu. See section 5.3.1.
•Verify the connections and cables of the connected devices.
The TV does not remember my settings when I switch back on
•Verify if the TV is set to Home in the TV menu > Setup > Installation > Preferences > Location menu.
The picture does not fit the screen, it is too big or too small
•Select a more fitting picture format in the Picture format menu.
See section 5.3.4 Widescreen picture format.
•Name your connected device in the Connections menu to obtain the best signal handling.
See section 7.4.1 Naming your devices.
The picture position on screen is not correct
•Some picture signals from some devices do not fit the screen correctly.You can shift the picture with the navigation key on the remote control.Verify the signal output of the device.
48 | Troubleshooting |
