Philips 42PFL9742D/19 manual Troubleshooting, Television and remote control, TV channels, Picture

2661.1 eng 03-07-2007 11:57 Pagina 44

9 Troubleshooting

Television and remote control

The TV does not switch on

•Verify the mains cord connection.

•Verify if the batteries of the remote control are flat or weak. Verify their + / - orientation.

You can use the keys on the TV to switch the TV on.

•Unplug the mains cord, wait for one minute and plug in the mains again.

The TV does not react on the remote control

•Verify if the batteries of the remote control are not empty or weak. Verify their + / - orientation.

•Clean the remote control and TV sensor lens.

•Use the side control keys to change some of the

basic settings of picture and sound.

‡Press Volume - and + to adjust the volume. ® Press Program/Channel - and + to go through

the channels marked as favourites. ÒPress Menu to show the main menu.

Press Program/Channel - and + to select and adjust picture and sound menu items.

The red light on the TV blinks

•Unplug the mains cord for half a minute and insert it again. Verify if there is enough space for ventilation. Wait until the TV has cooled down. When the TV does not restart to standby and the blinking occurs again, call our Customer Support Centre.

You forgot your code to unlock Child lock

•See section 5.8.3 Set code / Change code.

Wrong language in the TV menu ?

Follow these steps to change the language.

‡Press Menu on the remote control. ® Press navigation key right.

ÒUse navigation down to highlight the third line.

† Press navigation key right three times.

º Press navigation key up or down to select your language.

◊Press OK.

‹Press Menu to quit the menus.

TV channels

Some TV channels are gone

•Verify if the correct channel list is chosen.

•A channel could be uninstalled in the Rearrange menu.

No digital channels found during installation

•Verify if the TV supports DVB-T in your country. See the list of countries on the TV typeplate.

Picture

The blue light is on, but there is no picture

•Verify if the antenna is connected properly.

•Verify if the correct device is selected.

The sound is on, but there is no picture

•Verify the contrast or brightness setting in the menu.

The TV picture is poor

•Verify if the antenna is connected properly.

•Loudspeakers, non-earthed audio devices, neon lights, high buildings or mountains can influence the picture quality. Try to improve the picture by changing the antenna direction or place devices away from the TV.

•Verify if the correct TV system is chosen in the Manual installation menu.

•If only a certain channel is poor, try to fine tune this channel in the Fine tune menu. See section 6.2.3.

The picture has poor colour

•Verify the colour settings in the Picture menu. Select any of the Reset to standard settings in the Reset to standard menu. See section 5.3.2.

•Verify the connections and cables of the connected devices.

The TV did not remember my settings when I switch back on

•Verify if the TV is set to Home in the TV menu > Installation > Preferences > Location menu.

The picture does not fit the screen, it is too big or too small

•Select a more fitting picture format in the Picture format menu.

See section 5.3.4 Widescreen picture format.

•Name your connected device in the Connections menu to obtain the best signal handling.

See section 7.4.3 Naming your devices.

44 Technical data