17
Note
•If you are not receiving a signal from your cable service, contact the Cable provider.
•If you press 
or 
during autoprogram, this setup of TV channels will be cancelled.
•The initial autoprogram function can be executed for either Antenna or Cable only once. When you change the connection (Antenna / Cable), select Autoprogram again. ➟ p.24
•If there is no signal Input from the antenna terminal and no operation for several seconds after you Turn On the unit, helpful hints appears. Follow the instructions listed on the TV screen.
English
Initial setup
No channel is registered. Try Autoprogram again?
Verify that you have a cable connected to the “ANTENNA IN” jack on the back of the TV, the channel installation process
searches this connection. If you are using a cable or satellite box, please confirm the input which you have connected to the box and press “SOURCE” key on the remote control to select the appropriate source input.
Retry
Later
Select 
OK 
Skip
After an initial setup is completed...
• If you want to scan the channels automatically again. | |
Autoprogram | ➟ p.24 |
• You can add the desired cable and Analog channels
unmemorized by autoprogram. | |
Add channels | ➟ p.25 |
• If you want to change to another language.
| Language | ➟ p.31 |
• | If you want to change the location setting. | |
| Location | ➟ p.31 |
• | If you want to restore the picture setting. | |
| Settings assistant | ➟ p.23 |
