English
1
2
4 3 
2Place the toothbrush bristles against the teeth at a slight angle towards the gumline.
3Press the on/off button to switch on the Sonicare.
4Apply light pressure to maximise Sonicare’s effectiveness and let the Sonicare toothbrush do the brushing for you.
5Gently move the brush head slowly across the teeth in a small back and forth motion so the longer bristles reach between your teeth. Continue this motion throughout the brushing cycle.
Note:To make sure you brush evenly throughout the mouth, divide your mouth into 4 sections using the Quadpacer feature (see chapter ‘Features’).
6Begin brushing in section 1 (outside upper teeth) and brush for 30 seconds before you move to section 2 (inside upper teeth). Continue brushing in section 3 (outside lower teeth) and brush for 30 seconds before you move to section 4 (inside lower teeth).
7After you have completed the brushing cycle, you can
spend additional time brushing the chewing surfaces of your teeth and areas where staining occurs.You can also brush your tongue,
with the toothbrush switched on or off, as you prefer.
The Sonicare is safe to use on:
-Braces (brush heads wear out sooner when used on braces)
-Dental restorations (fillings, crowns, veneers)
Note:You can switch off the toothbrush at any time by pressing and holding the on/off button for 2 seconds.
Clean and White mode brushing instructions
The Clean and White mode consists of 2 minutes of Clean mode to clean the whole mouth and an additional 30 seconds of White mode to focus on the visible front teeth.
1Brush the first 2 minutes as instructed in steps
2After the 2 minutes of Clean mode, the White mode begins with a change in brushing sound and motion.That is your signal to start brushing the visible upper front teeth for 15 seconds
3At the next beep and pause, move to the visible lower front teeth for the final 15 seconds of brushing.
Brushing modes
The Sonicare automatically starts in the default Clean mode.To select a different brushing mode:
1Press the on/off button to toggle between modes.
,The green LED indicates the selected mode.
Note:You can only switch between modes when the toothbrush is switched on.
