Power Supply
Remote control
Important!
•Before using the remote control, remove the insulation plastic tab as shown
in figure 9.
•If the remote control does not function correctly or the operating range is reduced, replace the battery with a new (CR2025) type battery.
1Pull the battery tray out as shown in figure 9.
2Replace a new battery according to polarity indication, and fully insert the battery tray back to the original position.
•Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst:
•Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
•When inserting new batteries, do not try to mix old batteries with the new ones.
•Remove the batteries if the set is not to be used for a long time.
Batteries contain chemical substances, so they should be disposed of properly.
Using AC power
1Check if the power/mains voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.
2Connect the power cord to the
AC~ MAINS inlet and the wall socket. The set is now ready for use.
3To switch the set off completely, withdraw the power cord from the wall socket.
4Install the unit near the AC outlet and where the AC power plug can be easily reached.
•Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms. Children could seriously injure themselves as the free end of the cable may still be live if only the connector is removed from the MAINS socket at the back of the unit.
The type plate is located on the bottom of the set.
Auto power saving
•In CD and DOCK mode, if AZ1330D is in the PAUSE position for 5 minutes, it will auto switch to the stop position.
•In CD and DOCK mode, if AZ1330D is in the STOP position for 15 minutes, it will auto switch to standby to save power.
Helpful hints:
–To avoid unnecessary energy consumption, always press POWER on the set to power off the set after using the set.
CAUTION
-Visible and invisible laser radiation. If the cover is open, do not look at the beam.
-High voltage! Do not open.You run the risk of getting an electric shock. The machine does not contain any
-Modification of the product could result in hazardous radiation of EMC or other unsafe operation.
This set complies with the radio interference requirements of the European Union.
