AA/1.5V
Alkaline
Battery
Igniter Cap
Control
Knobs
Step 12
Place control knobs on the control panel. Remove igniter cap and insert battery with positive end of battery toward igniter cap. Ensure spring is in place inside igniter cap. Replace igniter cap and make sure the igniter is working properly.
Step 13
Attach one handle stand using two M6 X 12mm bolts and two
M6 nuts. Next insert hood handle into handle stand. Place the other handle stand over handle and attach by using two M6 X 12mm bolts and two M6 nuts.
Step 14
Attach air vent dampers to the inside of lid. Place air vent dampers on the inside of the unit with the adjustment tab sticking through one of the air vent holes. Using
M6 X 12mm bolt and M6 nut, secure vent cover to the unit. Do not over tighten the nut as this will make the vent difficult to open and close. Repeat for other air vent damper.
30
