Philips AZ 1009, AZ1010 WARNING, Problem, Possible cause, Solution, TROUBLESHOOTING, No sound, no power, not work, Poor cassette, sound quality, No reaction to, Recording does

TROUBLESHOOTING

WARNING

Under no circumstance should you try to repair the set yourself as this will invalidate the guarantee.

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to solve a problem by following these hints, consult your dealer or service center.

English

Problem	Possible cause	Solution
No sound,	VOLUME is not adjusted.	Adjust volume.
no power
	Headphones are connected.	Disconnect headphones.
	Mains cable is not securely connected.	Connect mains cable properly.
	Batteries are flat.	Insert fresh batteries.
	Batteries are inserted incorrectly.	Insert batteries correctly.
	Trying to change over from mains to	Remove the mains plug from the
	battery supply without removing the plug.	unit’s AC MAINS socket.
No reaction to	Electrostatic discharge.	Disconnect the set from power supply,
operation of any keys		reconnect after a few seconds.
Poor radio reception	Weak radio signal.	Direct the antenna for optimum
		reception.
	Interference caused by electrical equipment	Keep the radio away from electrical
	like TVs, computers, engines, etc.	equipment.
no or E indication	The CD is badly scratched or dirty.	Replace or clean the CD.
	No CD is inserted.	Insert a CD.
	The CD is inserted upside down.	Insert CD with label facing up.
	The laser lens is steamed up.	Wait until the lens has cleared.
The CD skips tracks	The CD is damaged or dirty.	Replace or clean the CD.
	SHUFFLE or PROGRAM is active.	Switch off SHUFFLE or PROGRAM.
Poor cassette	Dust and dirt on the heads, capstans or	Clean heads, capstans, and pressure
sound quality	pressure rollers.	rollers.
	Use of unsuitable cassette types	Only use NORMAL type cassettes for
	(METAL or CHROME) for recording.	recording.
Recording does	Cassette tab(s) may be snapped off.	Apply a piece of adhesive tape over
not work		the opening.

13