AZ 1565/00 page 13
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
English
PROBLEM
–POSSIBLE CAUSE
• REMEDY
No sound/power
–VOLUME not adjusted
• Adjust the VOLUME
–Headphones connected
• Disconnect headphones
–Mains lead not securely connected
• Connect AC mains lead properly
Severe radio hum or noise
The CD skips tracks
–CD damaged or dirty
• Replace or clean CD
–SHUFFLE or PROGRAM is active
• Switch off SHUFFLE / PROGRAM
Poor cassette sound quality
–Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
–Use of incompatible cassette types (METAL or CHROME)
• Only use NORMAL (IEC I) for recording
– Electrical interference: set too close to TV, |
| Recording does not work |
VCR or computer |
| – Cassette tab(s) may be broken |
• Increase the distance |
| • Apply a piece of adhesive tape over the |
Poor radio reception |
| missing tab space. |
|
|
–Weak radio signal
•FM: Direct the FM telescopic aerial for optimum reception
indication
–CD badly scratched or dirty
•Replace/ clean CD, see Maintenance
– Laser lens steamed up,
•Wait until lens has cleared
indication
–
• Use a finalised
Remote control does not function properly
–Batteries exhausted
• Insert fresh batteries
–Batteries incorrectly inserted
• Insert the batteries correctly
–Distance/ angle between the set too large
• Reduce the distance/ angle
Environmental information
All unnecessary packaging material has been omitted. We have done our utmost to make the packaging easy to separate into three
Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.
13
