User Manual BDL4771V
4.2.4.Configuration 1 MENU
Switch on state
Set the display to turn on or remain off when the power cord is connected to a wall outlet. Use the UP/DOWN button to toggle between
•Last status - The display will return to the previous power status (on/off/standby) when removing and replacing the power cord.
•Forced on - The display will turn on when the power cord is connected to a wall outlet.
•Power off - The display will remain off when the power cord is connected to a wall outlet.
Note: If you unplug the power cord and
Auto adjust
Note: For VGA input only.
Use this function to automatically optimize the VGA image within the display. Press SET to adjust.
Power save
Set the display to reduce the power consumption.
Use the UP/DOWN button to toggle between
•PC - Select On to let the display enter DPMS (Display Power Management Signaling) mode when no signal can be detected from the HDMI,
•Video - Select On to let the display enter power saving mode when no signal is detected from the Component input after three successive cycles. Use the PLUS/MINUS button to make your selection.
Language
Select the language for the OSD menu.
Use the UP/DOWN button to select a language.
Panel saving
Choose to enable the panel saving functions to reduce the risk of the "image persistence”. Use the UP/ DOWN button to toggle between
•Brightness - Select On and the brightness of the image will be reduced to an appropriate level, and the Brightness setting in the Picture menu will become unavailable. Use the PLUS/MINUS button to make selection.
•Pixel shift - Select the time interval for the display to slightly expand the image size and shift the pixel position in four directions (up, down, left, and right). Use the PLUS/MINUS button to make selection
IMPORTANT: It is not recommended to keep a single static image displayed on your unit for long periods of time. This can cause image sticking, or ghost imaging, which will decrease the quality of your images. In
RETURN TO THE CONTENTS
