Before Using the TV/VCR, Erasure Prevention | Philips CCZ192AT

CCZ191/CCZ191comb.QX33 4/6/99 6:42 PM Page 5

Putting Batteries in the Remote Control

1

Remove the battery compartment lid on the bottom of the remote control by sliding it in the direction of the arrow.

2

Place two AA batteries inside the battery compartment with their + and – ends aligned as indicated.

3

Replace the battery compartment lid.

Erasure Prevention

Video cassette tapes have record tabs to ensure that recordings are not accidentally erased.

1

To prevent accidental erasure, break off the tab with a screwdriver.

Before Using the TV/VCR 5

1

2 3

1

2

2

To record again, cover the hole with cellophane tape.

Using the Remote Control

●Point the remote control at the TV/VCR’s remote sensor.

●Do not put objects between the remote control and the TV/VCR.

VCR Maintenance

●In this TV/VCR, use only tapes with the mark.

●Make sure any light adhesive stick-on notes are removed from the video cassette tape before putting the tape in the TV/VCR. Removable labels like these can jam the TV/VCR.

●Periodic maintenance is required to maintain your TV/VCR’s excellent performance. This TV/VCR has an automatic head cleaning system. However, the video heads will eventually require cleaning or replacement. Cleaning or replacement of the video heads should be performed by an authorized service cen- ter.

Helpful Hints

•The remote control and its batteries are supplied.

•Do not mix alkaline and man- ganese batteries.

•Do not mix old and new batteries.

Image 5

Philips CCZ192AT Before Using the TV/VCR, Putting Batteries in the Remote Control, Erasure Prevention, VCR Maintenance

Contents

CCZ191AT CCZ192AT For Customer Use Dear Philips Magnavox product owner Introduction FeaturesSafety Precautions Table of Contents Putting Batteries in the Remote Control Before Using the TV/VCRUsing the Remote Control VCR Maintenance Hooking Up The TV/VCR Hook up your TV/VCR using one of the connections shownANTenna Jack on the TV/VCR Rod Antenna Audio and video cables are not supplied Hooking Up The TV/VCR cont’dBent pin Crooked Pin Straight Pin Press the Menu button. The screen shown below will appear You cannot set up channels if you are using a Cable BoxTurning On the TV/VCR Press the Menu button Language SelectionPress the PLAY/ button or the STOP/ button to select English or Español Spanish Press the STATUS/EXIT button Wait for the TV/VCR to set up channels Automatic Channel Setup Press the STATUS/EXIT button once or twice Adding/Deleting ChannelsProgramming of the channel you added or deleted will appear Manual Clock Setting Setting the Clock Setting the Clock cont’d Automatic PBS Channel Selection Message appears, turn off the TV/VCR for a few minutes. When Wait for the TV/VCR to find the time Manual PBS Channel Selection NOW Searching flashes on the TV/VCR screen Daylight-Saving Time Press the Menu button Time Zone Front Panel Rear Panel AC Power CordANTenna Jack Antenna Hole Remote Control Buttons ALT. CH Alternate Channel Button Volume / ButtonsChannel / Buttons Mute Button Adjusting the Picture Controls Decrease Increase Adjusting the Picture Controls cont’dMore brilliant Softer If you select Status ON, then select Counter only OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status OFF Reminder Playing Given below RecordingPress the RECord/OTR button once to start recording Recording options are on pages 30 OTR One-Touch Recording Audio and video cables are not included Rerecording Tape DuplicationDifferent brands of equipment may operate differently Daily Timer Recording Instructions continue on Timer Recording cont’d Please see page 48 for more Helpful Hints Checking or Clearing Timer Recordings Follow the steps below to prevent accidental recording Defeat Recording If the power fails, you might lose the sleep timer setting Setting the Sleep Timer Example Closed CaptionMenu Screen Half-screen text Closed Caption cont’dStandard Closed Captions PRIM. SETUP. Then, press the F.FWD/ B button Volume Bar Repeat Play B Repeat Play VCR SETUP, then press the F.FWD/ B buttonOver again Insert a tape in the TV/VCR Press the Menu button Flashing a will become a flashing B Repeat Play cont’d Appear on-screen Real-Time Counter Memory Automatic Operation Features Forward and Reverse Searching SP/LP/SLP Playback OptionsSuper High Speed Searching LP/SLP Viewing a Still Picture Glossary Specifications Helpful Hints Helpful Hints cont’d Model # Serial # Limited WarrantyPlease contact Philips at French Speaking English Speaking Index Supplied Accessories