Philips CD-D11U Mounting the Swivel and TV to the Stand, Making Basic Connections to the TV

Mounting the Swivel and TV to the Stand

1 Install the plastic position pins in the stand.

2 Place the TV and mounted swivel on the stand, aligning the front and sides of the TV with the front and sides of the stand. This will help properly seat the TV on the position- ing pins and align the pre-drilled holes on the stand and swivel. You do not need the rubber bumpers and long screws if you have already attached the swivel to the TV.

3 Use the supplied screws (2) and screw key to fasten the swivel to the stand. Install the back cover by sliding it up into the groove above the opening, the slide into the lower groove.

Note: If accessories and cables protrude from the stand, leave the back cover off.

4 Place accessory devices—HD satellite receiver, cable box, DVD player, or VCR, for example—inside the stand. (See below and Directions for Use manual for connection information.) Route the power cords through the opening in the bottom of the stand shelf, and route the connection cables through the openings in the back of the stand.

5 Before swiveling the TV, make sure you have left enough slack in the cords of any connected accessory devices. This will prevent damage to the cords.

3

NOTE: Installing these screws reduces the risk of the TV sliding.

1

Positioning

Pins

4

2

5

Screws

Placing the TV on the Stand

without the Swivel

If you should decide not to purchase the optional swivel, you can place the TV directly on the stand.

•First locate the nut and washer for each supplied rubber locator

(2).

•Place the rubber locators over the pre-drilled holes in the stand.

•Place the washer and nut on each rubber locator.

•Tighten each nut.

•Place the TV and mounted swivel on the stand, aligning the front and sides of the TV with the front and sides of the stand. This will help properly seat the TV. The rubber locators will prevent the TV from sliding.

Rubber Locators

Making Basic Connections to the TV

Cable TV

Connect the cable TV signal to the TUNER jack on the back of the TV. See page 8 for details on using Autoprogram to store chan- nels in the TV’s memory.

NOTE: This connection will supply stereo sound to the TV if it is being broadcast by the station you are watching.

					Back of TV
C
2
SERVICE 1
						DVI
		G S-VIDEO
AV1		R	L	V	AV6
		Pr	Pb	Y
MON	OUT	R	L	V		R	L
								Incoming
						R	L	Cable TV
		R	L	V
AV2								Signal
		G S-VIDEO			AV5
SUB OUT						RGB+HV
AV3		R	L	HD INPUTS		Pr	Pb	Y
				STANDARD/
								TUNER
AV4				STANDARD/		Pr	Pb	Y
		R	L	HD INPUTS

Connect the incoming cable TV signal to the TUNER jack on the back of the TV.

3