xp CDR 775/00.1 english
How to connect your recorder
Digital optical connection
Instead of the digital coaxial connection you can make use of the optical input.. Optical connections are less sensitive to external disturbances.This connection is required for direct recording from an external digital optical source (e.g. a CD player, DVD, DAT).
CD PLAYER |
|
|
|
|
|
|
CD RECORDER |
|
|
|
| 2 |
|
CD |
| CDR | CDR |
|
|
|
|
|
| CD | CDR | CDR | CDR |
|
|
|
|
| CD | |
L |
| L |
| L |
|
|
|
|
|
|
| ||
R |
| R |
| R |
|
|
OUT | OUT |
|
|
| ||
IN | OUT | IN | OUT |
| ||
ANALOG DIGITAL | IN | |||||
|
| ANALOG | DIGITAL | OPTICAL | ||
1 Remove the dust caps from the digital optical connections of both source and CD recorder. Keep the caps in a safe place.
2 Connect an optical
fully, until a click is heard.
➜Recording can now be done via the digital optical input (OPTICAL).
Digital coaxial connections via a digital receiver
If you have a receiver with digital coaxial in- and outputs, these connections allow you to make digital recordings from various sources, connected to the receiver.
DIGITAL |
|
|
|
|
|
| |
RECEIVER |
|
|
|
|
|
| |
CD RECORDER |
| 1 |
|
| 1 | ||
|
|
|
| ||||
CD |
| CDR | CDR |
|
|
| |
|
|
| CD | CDR | CDR | CDR | |
|
|
|
|
| CD | ||
L |
| L |
| L |
|
| |
|
|
|
|
| |||
R |
| R |
| R |
|
| |
OUT | OUT |
|
|
| |||
IN | OUT | IN | OUT |
| |||
ANALOG DIGITAL | IN | ||||||
ANALOG |
| ||||||
|
| DIGITAL | OPTICAL | ||||
1 Connect a digital coaxial cable between the DIGITAL IN- and OUT sockets on the CD recorder and e.g. the (digital) AUX in- and output sockets on the digital receiver.
➜Any digital device, connected to the digital input sockets of the digital receiver (e.g. CD and DVD) can now be used as recording source.
Note:Your CD recorder is equipped with a digital coaxial output (common output for CD recorder & CD player deck). This output can be used for digital playback.
Power supply/Mains
1 Check whether the mains voltage as shown on the type plate corresponds to your local mains voltage. If it does not, consult your dealer or service organisation.
2 Make sure all connections have been made before switching on the mains supply.
3 Plug the power cord supplied into the AC MAINS ~ connector and the CD recorder, then into the wall socket.
4 Press ON/OFF.
➜The CD recorder will switch on.This may take a few seconds.
Notes:
If the CD recorder is in Standby mode (red LED on), press any key to activate the recorder.
When the CD recorder is in the “OFF” position, it is still consuming some power. If you wish to disconnect your CD recorder completely from the mains, withdraw the plug from the AC Outlet.
English
13
