4-6

DISMANTLING INSTRUCTIONS

Dismantling the CDR module

continued

•to dismantle the Loader module:

-move tray completely out.

-loosen 4 screws to frame as shown in picture 18.

attention: flex wire to Mozart Board is too short for simple fetching the loader out. It is advised either

to dismantle the complete module as described on page 4-5 and to move it a few centimetres back or to loosen ferrite core as shown in picture 18a.

-put the module to a proper service position. → see also chapter SERVICE HINTS.

Press locking lug with a screwdriver down and move ferrite core out of its guiding. Turn ferrite core up and move it gently along the cable.

 

 

picture 18a

picture 18

 

 

 

•to dismantle the MOZART Board:

-loosen 2 screws to frame as shown in picture 19.

-unlock flex foil connector and disconnect flex wire.

-pull the board out of it´s guidings (backwards).

-place the Mozart board to a proper service position. → see also chapter SERVICE HINTS.

picture 19