Philips DC200/79 Power Supply, Self-Powered Back-Up, Basic Operation, Setting the Clock

POWER SUPPLY

Mains adaptor

1Connect the mains adaptor to the set's DC 9V socket and to the power socket.

Helpful hints: To avoid damage to the set, use only the adaptor supplied!

The power rating is located on the bottom of the set.

SELF-POWERED BACK-UP

The self-powered back-up conveniently allows your alarm and clock time settings to be stored for up to 10 minutes when there is a power interruption e.g. AC power failure. The complete clock radio and backlight illumination will be switched off.

If power supply returns after 10 minutes and the display shows:

• clock time blinking - indicates you need to re-adjust the clock time.

BASIC OPERATION.

Switching on the system

•Press POWER.

™ The system will switch to the last selected source.

Switching the system to standby mode

• In any source mode, press POWER.

Illumination brightness

Press REPEAT ALARM / BRIGHTNESS CONTROL once or more.

•The brightness of the display can be adjusted: Bright ➟ Low ➟ Off ➟ Bright .

SETTING THE CLOCK

1In standby mode, press and hold PROG/SET TIME until clock digits flashes.

2Hold down or press ¡1 / 2™ repeatedly to set and adjust the hours.

3Press PROG/SET TIME to confirm.

™ The clock digits for the minutes flash.

4Hold down or press ¡1 / 2™ repeatedly to set and adjust the minutes.