General Information

Congratulations on your purchase and welcome to Philips!

To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.

This set complies with the FCC rules, Part 15 and with 21 CFR 1040.10. Operation is subject to the following two conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause undesired operation.

Environmental Information

All unnecessary packaging has been omitted.We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Supplied accessories

remote control (with battery)

FM antenna

AM antenna

8 X iPod dock adaptors

1 X certified AC/DC adapter (Input: 100-

240V ~ 50-60Hz 1.2 A, Output:15V 3A)

Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side.

The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.

Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight.

No naked flame sources, such as lighted candles, should be placed on the apparatus.

No objects filled with liquids, such as vases, shall be placed on the apparatus.

Install this unit near the AC outlet and where the AC power plug can be reached easily.

The apparatus shall not be exposed to dripping or splashing.

If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player would not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.

The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

When the system is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

English

Safety Information

Before operating the system, check that the operating voltage indicated on the typeplate of your system is identical with the voltage of your local power supply. If not, please consult your dealer.

Place the system on a flat, hard and stable surface.

Where the MAINS plug or an appliance coupler is used as the disconnet device, the disconnet device shall remain readily operable.

9

Page 9
Image 9
Philips DCM230 quick start General Information, Environmental Information, Supplied accessories, Safety Information