6Restore your Wi-Fi enabled device back to your existing home Wi-Fi settings (see ‘Restore your Wi-Fi enabled device back to your existing home Wi-Fi setting’ on page 17).
Collect settings of your home Wi-Fi router
Note
Always consult the user manual of your home Wi-Fi router for detailed instructions.
1Connect your Wi-Fi enabled device to your existing home Wi-Fi network.
2Launch the Internet browser (for example, Apple Safari or Microsoft Internet Explorer) on your Wi-Fi enabled device.
3
home Wi-Fi router.
4Find the Wi-Fi settings tab and write down the following information on paper:
A Network name (SSID)
B Wi-Fi security mode (usually WEP, WPA or WPA2 if enabled)
C Wi-Fi password (if Wi-Fi security is enabled)
D DHCP mode (enabled or disabled) E Static IP address settings (if DHCP
mode is disabled)
Switch DS3800W to Assisted Wi-Fi Setup mode
Note
Before you press any button on DS3800W, make sure that DS3800W has been booted up successfully (see ‘Turn DS3800W on’ on page 10).
English
Press and hold Wi-Fi SETUP on the back of DS3800W for more than 5 seconds.
»The Wi-Fi SETUP indicator blinks green and yellow alternately.
»A new Wi-Fi network created by DS3800W will appear, with the network name (SSID) of Philips Fidelio AirPlay.
»It may take up to 45 seconds for successful creation of this new Wi-Fi network.
Note
the new Wi-Fi network created by DS3800W will disappear.
If you fail to enter Assisted Wi-Fi Setup mode, power off DS3800W and power on it, then try again after successful boot-up.
Make sure that there are no other Philips AirPlay- enabled devices in Assisted Wi-Fi Setup mode at the same time. Multiple Wi-Fi networks created this way may interfere with each other.
