Philips DVD701 Connecting the power cord, Remote control battery installation, NTSC/PAL Settings

- + - +

Connecting the power cord

1Plug the female end of the supplied power cord into the Mains (AC) jack on the rear of the player.

2Connect the other end of the cord to an AC outlet.

Note: When the player is in the “STANDBY” mode, it is still consuming some power. If you wish to disconnect your player completely from the power, press

POWER ON/OFF

Caution: Only qualified service personnel should remove the cover or attempt to service this device.

Remote control battery installation

Loading the batteries

1Open the battery compartment cover.

2Insert batteries as indicated inside the battery compartment.

3Close the cover.

Caution: Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).

NTSC/PAL Settings

You can switch the NTSC/PAL setting of the DVD player to match the video signal of your TV.This setting only affects the television’s on-screen display that shows the stop and setup modes.You may select either NTSC or PAL.To change the DVD player setting to PAL or NTSC, follow the steps below.

1Press the POWER ON/OFF button on the front panel of the DVD player to turn OFF the DVD player.

2Press and hold / and T on the front of the DVD player.While holding / and T, press POWER ON/OFF.

3After PAL or NTSC appears on the display panel of the DVD player, release / and T at the same time.The PAL or NTSC that appears on the display panel indicates the current setting.

4To change the setting, press T within three seconds.The new setting (PAL or NTSC) will appear on the display panel.

16 PREPARATION