Philips DVDR3435V/37 user manual Not work

98	Troubleshooting (cont’d)
	Symptom			Remedy
	“Repairing” appears on the TV screen.			• If there is a power failure or unplugging during recording, finalizing,
				formatting or editing (even after “Wait for a moment.” message is
				disappeared), a Repairing process will begin automatically just after
		Repairing		turning the unit on again.
D In a case you intend to cancel the				It may take several minutes up to about four hours.
				• If you intend to cancel the Repairing process, press
V	Repairing process.
				[OPEN/CLOSE A] on the front panel, then select “Yes” with
D				[{ / B] and press [OK]. After that, the disc tray will automatically
		Do you want to cancel a repairing process ?
		When selecting “Yes”, the disc may not be		open. In case the Repairing process is canceled, the disc MAY
		usable.		NOT work.
		Yes	No
		Repairing
	Picture noise appears.			• Head cleaning for VCR may be necessary. Refer to “AUTO HEAD
				CLEANING” on page 5.
				• Adjust tracking control for better picture by pressing [CHANNEL L / K]
				on this unit or [CH +/-]while you are playing a videotape.
V The tape does not play.				• No videotape is inserted.
C Recording does not start immediately				• Make sure the videotape has a record tab when you record to a
R	after you press [VCR REC I].			videotape. If needed, cover the hole with cellophane tape.
	The remote control does not			• Check if a videotape is in this unit.
	function.
	The motor rotates even when			• The motor may rotate for the duration of approximately 5 minutes for
	playback / recording is stopped.			efficient operation. This is not a malfunction.
	DV signal cannot be input.			• Before connection, turn on the power supplies for both this unit and the
				DVC, and make sure that these units have stopped.
				• Only a “DVC-SD” signal can be input from the DVC to this unit. Other
				types of signals are not supported.
				• Do not connect any device other than the DVC. Even if a recorder or
				PC with another DV terminal is connected, the DV function will not
				operate.
				• If the DVC is not recognized after connection, turn off the power supply
				for the unit and re-connect the DVC.
	The DVC cannot be operated with			• Signal input or DVC operation from this unit may be disabled depending
	this unit.			on the type of DVC.
D				• If a DVC signal cannot be input, use an external input (EXT1/EXT2) for
V				analog connection via AV cable.
				• DVC control may be disabled depending on the type of DVC, even in a
				mode other than camera mode. In this case, switch to DVD control and
				execute the normal recording procedure while operating the DVC.
	Certain functions of the unit cannot			• Some functions may not operate depending on the type of DVC. For
	operate.			example, if the DVC does not support slow playback mode, the slow
				playback function is disabled.
				• With E3(DV-IN), the disc display menu does not appear unless disc
				playback is executed.
	DV audio signal cannot be switched.			• For recording with the DVC, the recording audio signal can be set to 12
				bits or 16 bits. However, when 16-bit recording mode is selected, audio
				signal cannot be switched. To record an audio signal, set it to 12 bits.

E9A90UD_EN.indb 98

6/12/2006 4:23:36 PM