![](/images/new-backgrounds/1231325/23132527x1.webp)
Getting Started
E n g l i s h
Step 1: Inserting batteries into the Remote Control
3
1
2
1Open the battery compartment.
2Insert two batteries type R06 or AA, following the indications
3Close the cover.
Using the Remote Control to operate the Player
1Aim the Remote Control
Step 2: Setting up the TV
IMPORTANT!
Make sure you have completed all the necessary connections. (See pages
1 Turn on the TV and set to the correct |
Philips DVD background screen on the |
TV. |
➜ Usually these channels are between the |
lowest and highest channels and may be |
called FRONT,A/V IN, or VIDEO. See your |
TV manual for more details. |
➜ Or, you may go to channel 1 on your |
TV, then press the Channel down button |
repeatedly until you see the Video In |
channel. |
➜ Or, the TV Remote Control may have a |
button or switch that chooses different |
directly at the remote sensor (iR) on the front panel.
2Do not put any objects
STOP
video modes. |
➜ Or, set the TV to channel 3 or 4 if you |
are using an RF modulator. |
2 If you are using external equipment, (eg. |
between the Remote Control and the DVD Player while operating the DVD Player.
CAUTION!
–Remove batteries if they are exhausted or if the Remote Control is not being used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed properly.
audio system or receiver), turn it on and |
select the appropriate input source for |
the DVD Player output. Refer to the |
equipment owner’s manual for detail. |
14
14 | 8239 300 32131 | |
19/03/2004, 2:55 PM |