General
Setup 
OSD | Normal / Minimum |
General
Setup 
Programme title 
Yes / No
General
Setup 
Set/Change code 
Factory settings
This function allows you to reset most of the picture and sound settings to their predefined factory values.
&Select Factory settings with the cursor down.
éPress OK to erase settings and reset them to their default values.
OSD (On Screen Display)
&Select OSD with the cursor down.
éPress the cursor right to select Normal or Minimum.
Normal to activate extended display of TV channel and programme information on screen.
Minimum to activate the display of reduced channel information. See Use of the Remote Control, p. 10, i On screen information.
Note: When Subtitles is switched on, see Features, p. 16, display of the programme number is not possible.
Programme title
&Select Programme title with the cursor down.
éPress the cursor right to select Programme title Yes or No.
When selected Yes, after the selection of a TV programme or after pressing the i key on the remote control, a TV channel which broadcasts teletext may transmit the name of the TV channel or the programme title.
When selected No, the programme title will only appear after pressing the i key, and not after the selection of a TV channel.
Set/Change code
The Child lock feature (see TV, Features, p. 16) allows you to lock channels to prevent children from watching certain programmes.
To watch locked channels, you need to enter an access code.
The Set/Change code menu item allows you to create or change a Personal Identification Number (PIN).
&Select Set/Change code with the cursor down.
éIf no code exists yet, the menu item is set to Set code. Follow the instructions on screen.
If a code has previously been entered, the menu item is set to Change code. Follow the instructions on screen.
All number combinations from 0000 to 9999 are valid numbers.
“The General menu reappears with a message confirming that the code has been created.
Important:You have forgotten your code !
&Select Set/Change code in the General menu.
éPress OK.
“Press the cursor right.
‘Enter the overriding code
(Press the cursor again and enter a new personal
