Philips FW-V220/21 Demonstration mode, Selecting the Source, DIM mode, Switching the system ON

Operating the System

Demonstration mode

The system has a demonstration mode that shows the various features offered by the system.

To disable the demonstration mode

¶Press and hold Ç (on the system only) for 5 seconds when the system is in demonstration mode.

➜"DEMO OFF" is displayed.

➜The system will switch to standby mode.

To enable the demonstration mode

¶Press and hold Ç (on the system only) for 5 seconds when the system is in standby mode. ➜ The demonstration will begin.

Notes:

–If the demonstration mode has not been disabled, it will resume 5 seconds later after the system switches to standby mode.

–When the system is switched on from the main power outlet, the VCD changer tray may open and close again to initialize the set.

–Even though the AC power cord is removed from and reconnected to the wall socket, the demonstration will remain off until it is switched on again.

Selecting the Source

¶Press the respective source selection button: VCD, TUNER, TAPE or AUX.

➜ The display indicates the selected source.

Note:

–For an external source, make sure you have connected the audio left and right OUT terminals of the external equipment (TV,VCR, Laser Disc player, DVD player or CD Recorder) to the AUX IN terminals.

DIM mode

You can select the desired brightness for the display.

¶Press DIM to select DIM 1, DIM 2, DIM 3 or DIM OFF display mode.

➜The DIM display lights up.

➜"DIM 1", "DIM 2", "DIM 3" or "DIM OFF" will be displayed depending on the mode selected.

English

Switching the system ON

¶Press VCD, TUNER, TAPE or AUX.

¶Press STANDBY-ONin demo.

You can also switch on the system by pressing any one of the VCD DIRECT PLAY buttons.

Switching the system to standby mode

¶Press STANDBY-ONor B on the remote control.

➜ The system will switch to standby mode.

		13
pg 01-032/V220/21-Eng	13	3139 115 20823
		28/05/2001, 09:03 AM