Philips FW-V220/21 manual Video Cd, Erasing the programme when, Adjusting the TV System, En gli sh

CD / VCD / MP3-CD

En gli sh

2Press Ç to stop programme playback.

Note:

– If you press any other DISC DIRECT PLAY buttons, the system will play the selected disc or track and the stored programme will be cleared.

Erasing the programme (when

playback is stopped)

¶Press Ç.

➜ “PROGRAM CLEARED” will be displayed.

Note:

–The programme will be erased when the system is disconnected from the power supply or switched to standby mode when you change source or when you change the programme disc.

Repeat (only on remote control)

You can play the current track or a disc repeatedly.

VIDEO CD

OSD	2
VCD.CD 1/2/3 AUX TUNER TAPE 1/2

1		2	3
4		5	6
7		8	9
PROG		0	REPEAT
		VOLUME
		ÉÅ
TITLE			TITLE
-	í	ë +
à		Ç	á
ALBUM		IS	ALBUM
-			+
	DBB	DSC
PBC	RETURN DIGEST		A-B
ZOOM		RESUME	SLOW
			Ö
VOCAL		ECHO
		-	+

KEY CONTROL

#

1 Press REPEAT on the remote control to select	Adjusting the TV System
the various repeat modes.	Before viewing the Video CD, ensure that the set
➜ "REPEAT TRACK", "REPEAT DISC"or	is switched to corresponding PAL or NTSC
"REPEAT OFF" will be displayed.	system of your TV set (exception Multi – system
➜ The REP flag appears on the display.	TV).
¶ The current track or disc will now be played	● Press and hold PAL/NTSC for more than 2
repeatedly until you pressÇ.
	seconds to switch between PAL or NTSC TV
2 Press REPEAT until the "REPEAT OFF" mode
	system.
is displayed to resume normal playback.
	➜ After TV system is selected, the set will
➜ The REP flag disappears from the display.
	automatically switch to the last TV system setting
Notes:	every time the VCD source is selected.
– REPEAT DISC mode is not available during	Note:
programme play mode.
	– Before adjusting the TV system, make sure that
	there is no MP3-CD in disc tray 1 during power up.

OSD – On Screen Display

If you insert VCD/CD, your TV screen will serve as an additional display for messages (e.g. PLAY, STOP), and information stored on the VCD/CD.

● Press OSD on the remote control repeatedly to switch ON or OFF.

When OSD is switched ON; you can see the following display on the TV screen.

Below is an example of the OSD message.

18

pg 01-032/V220/21-Eng	18	3139 115 20823
		28/05/2001, 09:03 AM