Programming the disc tracks
Programming tracks is possible when playback is stopped. Up to 99 tracks can be stored in the memory in any order.
1Load the desired discs on the disc tray (refer to “Loading discs”).
2Press VCD 1/2/3 to select a disc.
➜Programming can only be done on the selected disc.
3Press PROG to start programming.
➜PROG starts flashing.
4Press í or ë (or numeric keys
●For MP3 disc, press ALBUM
5Press PROG to store the track.
●Repeat steps
6To end programming, press Ç once.
➜PROG stays and the programme mode remains active.
➜The total number of tracks programmed and the total playing time are displayed.
➜For MP3 disc, total playing time will not be shown.
7To start programme play, pressÉÅ.
➜"PLAY PROGRAM" is displayed.
Notes:
–To programme from a video CD, the PBC mode has to be switched off.
–It is not possible to create a programme with MP3 tracks from multiple CDs, or combined with normal audio tracks.
–If the total playing time is more than "99:59" then
–If you attempt to programme more than 99 tracks, "FULL" is displayed.
–During programming, if no button is pressed within 20 seconds, the system will exit the programme mode automatically.
To review the programme
●Stop playback and pressí or ë repeatedly.
●To exit review mode, press Ç.
Erasing the programme
●Press Ç once when playback is stopped or twice during playback.
➜ PROG disappears and "PROGRAM CLEARED" is displayed.
Note:
–The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened.
For Recording, please refer to “Tape Operation/Recording”.
E n g l i s h
19
pg | 19 | 4/17/02, 1:15 PM 3139 115 21372 |
