Philips FW-V355 manual Clock/Timer, Sleep timer setting, Deactivating the timer

	Clock/Timer
En	2 Press VCD 1/2/3, TUNER or TAPE to select
	the desired source.
gli	➜ “CD1 [or 2, 3] XX:XX" indicates the CD
sh	mode is selected.
	➜ “TU XX:XX” indicates the Tuner mode is
	selected.
	➜ “TA1 [or 2] XX:XX” indicates the Tape
	mode is selected.
	● Before setting timer, make sure the music source
	has been prepared.
	VCD 1/2/3 – Load the disc(s).
	TUNER – tune to the desired radio station.
	TAPE – load the prerecorded tape into tape
	deck.
	3 Press à or á on the system repeatedly to set
	the hour for the timer to start.
	4 Press í or ë on the system repeatedly to set
	the minute for the timer to start.
	5 Press CLOCK•TIMER to store the timer.
	➜ "TIMER ON" is displayed, followed by the set
	timer "XX:XX" and the selected source.
	➜ remains on the display.
	● At the preset time, the selected sound source
	will play.
	To exit without storing the setting
	● Press Çon the system.
	Notes:
	– When the preset time is reached and the
	selected disc tray is empty, the next available disc
	will be selected. If all the disc trays are not
	available,Tuner will be selected automatically.
	– During timer setting, if no button is pressed
	within 90 seconds, the system will exit timer setting
	mode automatically.

Deactivating the timer

1Press and hold CLOCK•TIMER for more than two seconds.

2Press Ç on the system to cancel the timer.

➜ "CANCEL" is displayed and the disappears.

30

pg 001-034/V355/21-Eng 30

Activating the timer (for the same preset

time and source)

1Press and hold CLOCK•TIMER for more than two seconds.

2Press CLOCK•TIMER again to store.

➜ The last set timer information is displayed for a few seconds and is shown.

Sleep timer setting

The sleep timer enables the system to switch to standby mode automatically at a preset time.

1Press SLEEP repeatedly to select a preset time.

➜The selections are as follows (time in minutes):

15 ™ 30 ™ 45 ™ 60 ™ 90 ™ 120 ™ OFF ™ 15 …

➜"SLEEP XX" or "OFF" is displayed. "XX" is the time in minutes.

2When you reach the desired length of time, stop pressing the SLEEP button.

➜ is shown, except for "OFF" mode.

➜The sleep timer is now set. Before the system switches to standby mode, a countdown of 10 seconds is displayed.

"SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1"

™"SLEEP"

To check the remaining length of time after sleep timer is activated

●Press SLEEP once.

To change the preset sleep timer

●Press SLEEP again while the remaining sleep timer is shown.

➜ The display will show the next sleep timer options.

To deactivate the sleep timer

●Press SLEEP repeatedly until "OFF" is displayed, or press the STANDBY ON button.

4/17/02, 1:15 PM 3139 115 21372