Philips FW-V355 Radio Reception, Tuning to preset radio stations, Erasing a preset radio station

Models: FW-V355

1 34
Download 34 pages 34.09 Kb
Page 25
Image 25
Radio Reception

Radio Reception

Note:

If no preset number is selected, automatic preset will begin from preset (1) and all your former presets will be overridden.

Manual Preset Programming

1Tune to your desired radio station (refer to “Tuning to radio stations”).

2Press PROG.

PROG starts flashing.

The next available preset number is displayed for selection.

To store the radio station to another preset number

Press í or ë to select the desired preset number.

3Press PROG again to store the radio station. PROG disappears.

Repeat steps 1–3to store other radio stations.

To exit manual preset mode

Press Ç on the system.

Notes:

If you attempt to store more than 40 preset radio stations, "FULL" is displayed.

During programming, if no key is pressed within 20 seconds, the system will exit the programme mode automatically.

Tuning to preset radio stations

Once you’ve programmed the radio stations, press í or ë to select the desired preset number.

The preset number, radio frequency, and waveband are displayed.

Erasing a preset radio station

1Press í or ë to select the preset radio station to be erased.

2Press and hold Çon the system until “PRESET DELETED” is displayed.

The deleted radio frequency remains on the display.

The preset numbers of all other preset radio stations in the band with higher numbers are also decreased by one.

Repeat steps 1–2to erase other preset radio stations.

Changing tuning grid (not available for

all versions)

In North and South America, the frequency step between adjacent channels in the MW band is 10 kHz (9 kHz in some areas). The preset frequency step in the factory is 9 kHz.

Changing the tuning grid will erase all previously stored preset radio stations.

1Disconnect the system from the AC power supply (pull out the AC power cord).

2While holding down TUNER and á on the system, reconnect the system to the AC power supply.

The display will show "GRID 9" or

"GRID 10".

Notes:

GRID 9 and GRID 10 indicate that the tuning grid is in step of 9 kHz and 10 kHz respectively.

The FM tuning grid also will be changed from 50 kHz to 100 kHz or vice versa.

For Recording, please refer to “Tape Operation/Recording”.

E n g l i s h

25

pg 001-034/V355/21-Eng

25

4/17/02, 1:15 PM 3139 115 21372

Page 25
Image 25
Philips FW-V355 manual Radio Reception, Tuning to preset radio stations, Erasing a preset radio station, E n g l i s h