English
SETTING UP FB219W
The following equipment are supplied with the FB219W package:
–AC/DC adapter
–transmitter unit
–2 wireless surround speakers
–2 power cables for the surround speakers
–1 center speaker
–1 cinch cable
Transmitter
2 | 3 | 4 |
3 | R (SURR) |
|
| To connect the transmitter unit to the | |
| SURROUND OUT (SURR PRE OUT) jack | |
| of your set. |
|
4 | SURR / MULTI | |
| Set this selector to SURR, the position | |
| MULTI is not used with the supplied | |
| configuration. |
|
5 | A·B·C |
|
| To set the input sensitivity of the | |
| transmitter unit. | |
| A | maximum sensitivity |
| B | medium sensitivity |
| C | minimum sensitivity |
6 | 14 V |
|
| Connect the provided AC/DC adapter | |
| here. |
|
7 | CHANNEL |
|
| 7 step channel selector for setting the | |
Active surround speakers
10
11
9
8 | 12 |
8z
GREEN LIGHT: If this is on, the active speaker is on.
9y
RED LIGHT: If this is on, the active speaker is in standby mode.
Note:
Connections
Important!
Always switch off all your equipment before making any connections!
Front speakers and center speaker
Connect the colored speaker wire to the coloured or + terminal, and the black wire to the black or - terminal of the appliance.
Surround speakers
Connect the active speakers to the power source with the power cable provided. Switch on the active speaker with the POWER switch.
Transmitter unit
Connect the SURR terminal of the
1
5
6
7
channel in case of interferences. |
Notes:
–If both lights are off the active speaker is switched off or is not connected to a power source.
transmitter with the PRE OUT (SURROUND) terminal of the appliance using the supplied cinch cable. Connect the AC/DC
1Status light
RED ............... Transmitter is on. BLINKING ...... Transmitter is on and
input level is too high (see 5).
OFF ................ Transmitter is in standby mode or is not connected to the AC/ DC adapter.
2L (SUB)
Not used with the supplied configuration.
–Always be sure that the transmitter unit and the active surround speaker are switched to the same channel, otherwise no sound or only a distorted sound will be heard on the surround speakers.
–Cellular phones used near the system
–You have to switch off the active surround speaker before setting the transmitting channel.
10CHANNEL
7 step channel selector for setting the channel in case of interferences.
11POWER
To switch the active surround speaker on and off.
12MAINS
To connect the active surround speaker to the power source.
adapter supplied to the 14 V socket of the transmitter. Then connect the AC/DC adapter to the power source.
Note:
–The SUB terminal of the transmitter is not used with this set.
12
