7Adjust the sound of all the speakers until they are equal. When you are satisfied with the setting, press TEST TONE again to switch off the test signal.
Note:
–It is advisable to set the speakers’ level at normal listening level. "XX" denotes the sound level.
When you have completed the Dolby Pro Logic setup, you are ready to enjoy Home Cinema sound.
Dolby Surround
This setting is for a full Dolby Surround Pro Logic mode.
• Press DPL to select the Dolby Surround mode.
ª The message
“DOLBY
C
SURROUND”
will be | L | R |
| PRO LOGIC | |
displayed. | S | S |
|
ªThe DPL display panel will light up.
Dolby 3 Stereo
Use this setting when full surround is not required, but a wide stereo sound is desired. It only requires the left, right and center speakers.
•Press DPL to select the Dolby 3 Stereo mode.
ª The message
“DOLBY 3 |
| C |
STEREO” | L | R |
will be |
| PRO LOGIC |
displayed. | S | S |
|
|
ª The DPL display |
DOLBY PRO LOGIC
Important!
1For the best Dolby Pro Logic sound, switch on DPL with DSC set to “Classic” and with Incredible Surround off.
2Dolby Pro Logic mode will automatically switch to normal Stereo mode when headphones are connected.
3Switch to normal stereo mode when you record on a tape.
English
•Press DPL (PRO LOGIC) repeatedly to select and cycle through the various sound modes.
DPLM
BALANCE
L R
Dolby Center Phantom
This setting is for use without the center speaker. It redistributes the center speaker
panel will light |
up. |
Normal Stereo
Dolby Surround ª Center
Phantom ª Dolby 3 Stereo ª
Stereo ª Dolby Surround …
ªThe Dolby Pro Logic display panel will light up with the selection.
sound to the left and right speakers, providing conventional stereo across the front.
•Press DPL to select the Dolby Pro Logic Center Phantom mode.
ªThe message
“CENTER
PHANTOM” |
| C | |
L | R | ||
will be | |||
| PRO LOGIC | ||
displayed. |
| ||
S | S | ||
ª The DPL display |
|
| |
panel will light |
|
| |
up. |
|
|
This setting is for normal stereo sound without Dolby Pro Logic. It only requires the left and right speakers.
•Press DPL to select the Stereo mode.
ªThe message
“STEREO”C will be
displayed. | L | R |
| PRO LOGIC | |
ª The DPL display | S | S |
|
| |
panel will light |
|
|
up. |
|
|
15