English
SETTING UP FB219W
Switching On.Standby.Off
The transmitter is equipped with a sensitive input. If there is no signal on the SUB and SURR input the transmitter and the surround speakers will switch to standby after approximately 100 seconds.
The green light on the front of the active surround speakers shows that the speakers are on. If the red light is on, the speakers has switched to standby. To switch the active speakers off, use the POWER switch.
If the red light on the front of the transmitter is off, it has switched to standby. To switch the transmitter off, unplug the AC/DC adapter from the power source.
General Information
Any amplifier or receiver used at high power can produce distortions which may seriously damage your speakers. If distortion occurs, reduce the volume and the tone control to a level where the sound is acceptable again.
When using microphones, avoid feedback which occurs when a microphone picks up sound from the speakers, resulting in a howling noise. Keep the microphone away from the speakers or reduce the volume.
More wireless products …
The transmitter is also equipped to drive an optional wireless subwoofer, wireless stereo speakers or wireless headphones.
Please ask your dealer about these products. Refer to the instructions provided with these products before using them with your transmitter.
DOLBY PRO LOGIC
Dolby Pro Logic
This state of the art Dolby Pro Logic mini system enables you to experience and enjoy a Home Cinema sound ambience. The Pro Logic system allows more accurate definition of the individual sound sources. It produces greater sound separation between channels and provides pinpoint sound localization. Pro Logic provides four sound outputs: Left, Center, Right and Surround (Rear). Front sounds are produced from the pair of Left and Right speakers and a Center speaker. The surround sound is reproduced by two speakers placed at the rear of the listening area. Although the surround sound is monaural
This Pro Logic decoder enables you to decode the following modes: Dolby
Surround, Center Phantom, Dolby 3 Stereo or normal Stereo.
Test Tone
This feature enables you to adjust the Front Left, Front Right, Center and Surround Sound levels of the respective speakers in Dolby Pro Logic mode.
You must sit at the ideal sitting position and use the remote control to perform this operation.
1Press CD, TUNER, TAPE or AUX to switch on the system.
2Press TEST TONE.
ª A test signal is
generated; it will | UTE | TEST |
move through the |
| TONE |
| CENTER | |
Left, Center, Right, |
| |
|
| |
and Surround |
|
|
speakers, in that order. |
|
ª"TEST TONE" followed by
"ADAPT BALANCE, CENTER AND REAR LEVEL" will be displayed.
ªThe test signal will last for about 90
seconds.
3Press
BALANCE |
| BALANCE | CENTER | |
L | R | - + | ||
L to adjust | ||||
|
| REAR | ||
the sound |
| - | + | |
of the front |
|
|
| |
left speaker. |
|
|
|
ªThe display will show BAL L+XX.
4Press BALANCE R to adjust the sound of the front right speaker.
ªThe display will show BAL R +XX.
5Press CENTER +or
ªThe display will show either CENT +XX or
6Press REAR +or
ªThe display will show either REAR +XX or
14