Preparations
IMPORTANT!
–Make sure to complete the preparation procedures before operating the system.
Step 1: Inserting batteries into the remote control
3
1
2
1Open the battery compartment.
2Place two batteries (Type R06 or AA) in the compartment with the correct polarity as indicated by “+” and
3Close the cover.
Using the remote control to operate the
system
1Point the remote control directly
at the remote sensor (IR) on the front panel.
2Select the source you wish to
control by pressing one of the source select buttons on the remote control (for example TAPE1/2,TUNER).
3Then select the desired function (for example 2;, O or P).
CAUTION!
–Remove batteries if they are exhausted or will not be used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed of properly.
Step 2: Setting the clock
The clock can be set in either
1The clock can be set in any source mode. ➜ If you have not set the clock,
2Press and hold CLOCK/TIMER until “SELECT CLOCK OR TIMER” is displayed.
➜Press O or P to change the display to “CLOCK”.
➜Press CLOCK/TIMER again to confirm.
3Press O or P on the system to set the hours.
4Press 1 or ¡ on the system to set the minutes.
5Press CLOCK/TIMER to confirm your setting. The system will store the setting automatically
and go back to its previous status.
➜The time setting becomes effective. Note:
– In AUX mode, setting clock using remote control is not possible.
To exit the setting without storing (in standby mode)
●Press 9 on the system to exit.
➜“CANCEL” will appear on the display.
●Press STANDBY ON to exit setting mode and go into POWER ON mode.
●You can also press DISC, DISC1~3, DISC CHANGE, OPEN/CLOSE to exit setting mode and go to disc mode.
●The system will also exit setting mode and go to TUNER,TAPE or AUX mode when you press the corresponding source button.
Viewing the clock in any source mode
●When you have set the clock, press CLOCK/ TIMER to view clock. Press DISPLAY on the system to toggle between
➜The time will be displayed for 5 seconds and then the system will go back to its previous status.
English
21