Clock/Timer
English
Timer setting
The system can switch on to CD or TUNER mode automatically at a preset time, serving as an alarm to wake you up.
IMPORTANT!
–Before setting the timer, ensure that the clock is set correctly.
–The timer will always be switched on after it has been set.
–The timer will not start if a recording is in progress.
–The volume of the timer will increase gradually from the minimum level to the last tuned volume level.
1 Press and hold CLOCK•TIMER for more than
two seconds to select timer mode. ➜ The last timer setting starts flashing. ➜ TIMER starts flashing.
➜ The selected source will be lighted and flashing.
2Press CD or TUNER to select the desired source.
●Before setting timer, make sure the music source has been prepared.
CD Ð Load the disc(s).To start from a specific track, make a programme (refer to ÒCD Operation - Programming the disc tracksÓ). TUNER Ð tune to the desired radio station.
3Press
4Press
5Press CLOCK•TIMER to store the start time. ➜ TIMER remains on the display.
●At the preset time, the selected source will play.
To exit without storing the setting
●Press STOP Ç on the system. Notes:
–When the preset time is reached and the selected disc tray is empty, the next available disc will be selected. If all the disc trays are not available,Tuner will be selected automatically.
–During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically.
To deactivate the TIMER
●Press TIMER ON/OFF on the remote control. ➜ The display will show "OFF" and TIMER will disappear from the display.
To activate the TIMER
●Press TIMER ON/OFF on the remote control. ➜ The last set timer information will be shown for a few seconds and TIMER will appear on the display.
Sleep timer setting
The sleep timer enables the system to switch to standby mode automatically at a preset time.
1Press SLEEP on the remote control repeatedly to select a preset time.
➜The selections are as follows (time in minutes):
15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 É
➜"SLEEP XX" or "OFF" is displayed. "XX" is the time in minutes.
2When you reach the desired length of time, stop pressing the SLEEP button.
➜SLEEP is shown, except for "OFF" mode.
➜The sleep timer is now set. Before the system switches to standby mode, a countdown of 10 seconds is displayed.
"SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1"
™"SLEEP"
To check the remaining length of time after sleep timer is activated
●Press SLEEP once.
To change the preset sleep timer
●Press SLEEP again while the remaining sleep timer is shown.
➜ The display will show the next sleep timer options.
To deactivate the sleep timer
●Press SLEEP repeatedly until "OFF" is displayed, or press
28
