24
7 Fill the water reservoir up to the MAX indication with the descaler
mixture. Then put the water reservoir back onto the coffee machine.
8 Press the on/off button 3.
,The machine is ready for use when the light ring around the on/off
button lights up continuously.
9 Place the 1-cup pod holder q with a used coffee pod in the coffee
machine. Close the lid and make sure it is properly locked.
Note: Always put a used coffee pod in the pod holder when you descale the
machine. This pod serves as a ‘lter’ to prevent the sieve in the pod holder from
getting clogged with scale residues.
10 Put a bowl with a capacity of at least 1.5 litres under the spout to
collect the descaling mixture.
11 Press the CLEAN/CALC CLEAN button to start the descaling cycle.
Never interrupt the descaling cycle. If you did interrupt the descaling
cycle, see problem ‘The descaling cycle lasted only 5 minutes’ in
chapter ‘Troubleshooting’.
Never descale the SENSEO® coffee machine with the lid open. Make sure
the lid is properly locked.
,It takes a few seconds before the descaling cycle starts.
,During the descaling cycle, the machine pauses a few times to
remove scale deposits from the inside of the SENSEO® machine.
,During the descaling cycle, the indicators on the control panel on
the lid light up clockwise sequentially to indicate that the machine is
descaling.
,The descaling cycle takes about 35 minutes. When the descaling
cycle is nished, the CALC CLEAN indicator lights up again to
indicate that you have to perform 2 rinsing cycles.
rinsing cycles
1 Empty the water reservoir, rinse it and ll it with fresh water.
Caution: Do not rell the water reservoir with hot water or the used
descaling mixture.
EnglisH24