Note
•If the wireless connection fails again, check whether there is any confl ict or strong interference (for example, interference from other electronic devices) around your location.After removal of the confl ict or strong interference, repeat the above procedures.
Find the correct viewing channel
1Press to turn on the unit.
2Press DISC to switch to disc mode.
3Turn on theTV and switch to the correct
•Go to the lowest channel on yourTV, then press the Channel Down button until you see the blue screen.
•Press the source button repeatedly on the remote control of yourTV.
Tip
•The
Select the correct TV system
Change this setting if the video does not appear correctly. By default, this setting matches the most common setting forTVs in your country.
1Press OPTIONS.
2Select [Video Setup].
3Select [TV Type] and then press .
4Select a setting and then press OK.
•[PAL] - ForTV with PAL color system.
•[NTSC] - ForTV with NTSC color system.
•[Multi] - ForTV that is compatible with both PAL and NTSC.
5To exit the menu, pressOPTIONS.
Select menu display language
1PressOPTIONS.
2Select [General Setup].
3Select [OSD Language] and then press .
4Select a setting and then press OK.
5To exit the menu, press OPTIONS.
Turn on Progressive Scan
Progressive scan displays twice the number of frames per seconds than interlaced scanning (ordinaryTV system).With nearly double the number of lines, progressive scan offers higher picture resolution and quality.
Before you turn on this feature, ensure that:
•TheTV supports progressive scan signals.
•You have connected this unit with the TV through component video.
1Turn on theTV.
2Ensure that theTV progressive scan mode is deactivated (see theTV user manual).
3Switch theTV to the correct viewing channel for this unit.
4Press DISC.
5Press OPTIONS.
6Press / to select [Video Setup] in the menu, then press .
7Select [Progressive] > [On], then press
OK.
» A warning message is displayed.
8To proceed, select [Ok] and press OK. » The progressive setup is complete.
18EN