Philips HSB4383/12 user manual Use Philips EasyLink, Turn off progressive scan manually

Note

•If a blank/distorted screen is displayed, wait for 15 seconds for auto recovery or turn off progressive scan manually.

9Turn on the progressive scan mode on the TV.

Turn off progressive scan manually

1Turn off the progressive scan mode on the TV.

2Press OPTIONS.

3Press / to select [Video Setup] in the menu, then press .

4Select [Progressive] > [Off], then press OK.

5To exit the menu, press OPTIONS.

Use Philips EasyLink

This unit supports Philips EasyLink, which uses the HDMI CEC (Consumer Electronics Control) protocol. EasyLink-compliant devices that are connected through HDMI connectors can be controlled by a single remote control.

Note

•Philips does not guarantee 100% interoperability with all HDMI CEC devices.

1 Turn on the HDMI CEC operations on the TV or other connected devices. SeeTVs/ devices manual for details.

2You can now enjoy the following Philips EasyLink controls.

One touch play[Auto Wakeup TV]

When you press , this unit will wake up from standby mode and start disc play (if a video disc is found in the disc compartment). At the same time, yourTV will also be turned on and be switched to the correct viewing channel.

One touch power-off[System Standby] When you connect this unit to devices that support standby mode, you can use the remote control of this unit to switch this unit and all connected HDMI devices to standby mode.You can also use the remote control from any of the connected HDMI devices to perform one-touch standby .

One touch audio play[System Audio Control] When you connect this unit to HDMI

CEC compliant devices, the unit can switch automatically to play audio from the connected device.

English

EN 19