•Install all batteries correctly, + and - as marked on the unit.
•Do not mix batteries (old and new or carbon and alkaline, etc.).
•Remove batteries when the unit is not used for a long time.
oApparatus shall not be exposed to dripping or splashing.
pDo not place any sources of danger on the apparatus (e.g. liquid fi lled objects, lighted candles).
qThis product may contain lead and mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org.
Safety-Important notes for users in the U.K.
Mains plug
This apparatus is fi tted with an approved 13 Amp plug.To change a fuse in this type of plug proceed as follows:
aRemove fuse cover and fuse.
bFix new fuse which should be a BS1362 5 Amp,A.S.T.A. or BSI approved type.
cRefi t the fuse cover.
If the fi tted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fi tted in its place.
If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.
Note:The severed plug must be disposed off to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L).
As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows:
•Connect the blue wire to the terminal marked N or coloured black.
•Connect the brown wire to the terminal marked L or coloured red.
•Do not connect either wire to the earth terminal in the plug, marked E (or e) or
coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Copyright in the U.K.
Recording and playback of material may require consent. see Copyright Act 1956 andThe performer’s Protection Acts 1958 to 1972.
Warning
•Never remove the casing of this unit.
•Never lubricate any part of this unit.
•Place this unit on a fl at, hard and stable surface.
•Never place this unit on other electrical equipment.
•Only use this unit indoors. Keep this unit away from water, moisture and
•Keep this unit away from direct sunlight, naked fl ames or heat.
•Never look into the laser beam inside the unit.
Warning
•Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
Wall mounting of the unit should only be performed by qualifi ed personnel.The unit must only be mounted on an appropriate wall bracket and on a wall that can safely hold the weight of the unit. Improper wall mounting can result in severe injury or damage. Do not attempt to wall mount the unit yourself.
6EN
