SETUPS

Enable(Easy)

 

“Advanced

“Network

 

“Enable

home A“Settings” A

Setup”

A“Others” AConnection”

A

(Easy)”

Network settings are set to the following settings initially. (In most cases, you can connect to the Internet without making any changes to the default settings.)

- IP Address Setting

Auto(DHCP)

- DNS Setting

Auto(DHCP)

- Proxy Setting

Do Not Use

- Connection Speed

Auto

- BD-Live Setting

Allow

If you want to set the network settings back to the default settings as above (except “BD-Live Setting”), follow the procedure below.

1)Follow steps 1) to 4) in “Connection Test” on page 52.

2)Use [K / L] to select “Enable(Easy)”, then press [OK].

•The unit will start the connection test automatically and the test result will appear right after the test finishes.

•After the connection test finishes, press [OK] to go to network status confirmation screen.

3)Press [OK] to activate the network settings and set

the network connection automatically. [ (home)] to go back to the home menu.

Note

•The setting of “BD-Live Setting” will not be set back to the default, even if you follow the procedure.

Enable(Custom)

home A“Settings” A“AdvancedSetup” A“Others” AConnection”“Network A(Custom)”“Enable

In following cases, select “Enable(Custom)” to set each setting as necessary.

-When connection test failed with the setting of “Enable(Easy)”.

-When instructed by your Internet service provider to make specific settings in accordance with your network environment.

IP Address Setting / DNS Setting

1)Follow steps 1) to 4) in “Connection Test” on page 52.

2)Use [K / L] to select “Enable(Custom)”, then press [OK].

3)Use [K / L] to select “IP Address Setting”, then press [OK].

4)Use [K / L] to select the desired setting, then press [OK].

“Auto(DHCP)”

: If your router has DHCP server

 

function, select “Auto(DHCP)”.

“Manual”

: If your router does not have DHCP

 

server function, select “Manual”.

 

 

If you select “Manual”, follow the following instruction to set the IP address and DNS.

4-a) IP address setting screen will appear. Enter IP address, subnet mask and default gateway with cursor buttons and number buttons.

IP Address Setting

IP Address

Subnet Mask

Default Gateway

Clear

OK

•Enter the IP address number after checking the specifications of your router.

•If the IP address is unknown, check the IP address of other devices. (e.g. PC connected via LAN cable) and assign a different number from those of other devices.

After you enter all correctly, press [OK] to go to the DNS setting screen.

4-b) DNS setting screen will appear. Enter primary DNS and secondary DNS with cursor buttons and number buttons.

DNS Setting

Primary DNS

Secondary DNS

Clear

OK

•Enter the DNS addresses provided by your Internet provider.

•If the DNS address is unknown, check the DNS address of other devices (e.g. PC connected via LAN cable) and assign the same DNS address.

4-c) After you enter all correctly, press [OK].

•Confirmation message will appear. Select “Yes” to complete the settings.

IP Address

xxx.xxx.xxx.xxx

Subnet Mask

xxx.xxx.xxx.xxx

Default Gateway

xxx.xxx.xxx.xxx

Primary DNS

xxx.xxx.xxx.xxx

Secondary DNS

xxx.xxx.xxx.xxx

 

Is Setting OK?

 

Yes

 

No

5)Press [BACK U] to go back to the previous screen, or press [ (home)] to go back to the home menu.

EN

Others Setup Function Functions Other Playback Setup Basic Connections Introduction

EN 53