Audio setup
Audio Setup
Speakers Volume
Speakers Delay
HDMI Audio
CD Upsampling
Audio Sync
1 PressSETUP.
»[General Setup] menu is displayed.
2 Press to select [Audio Setup], then press .
3 Select an option, then press OK.
4 Select a setting, then press OK.
•To return to the previous menu, press BACK.
•To exit the menu, press SETUP.
Note
•See the explanations of the above options in the following pages.
[Speakers Volume]
Sets the volume level of each speaker to get the ideal audio balance.
1)To start, press OK.
2)Select a speaker in the menu, then press to adjust the volume level.
3)Press OK to confirm and exit.
Note
•The test tone is emitted from the speaker which you adjust.
34EN
[Speakers Delay]
Sets the delay time for the centre and rear speakers if they are placed closer to the listening position, so that the sound output from all speakers reaches the listening position at the same time.
1)To start, press OK.
2)Select a speaker in the menu, then press to set the delay time.
3)Press OK to confirm and exit.
Note
•Allow 1 ms setting for every 1 foot distance between the speaker and the listening position.
[HDMI Audio]
Selects the HDMI audio setting when you connect this Home Theatre System and the TV with a HDMI cable.
•[On] – Allows audio output through the TV and the speaker system. If the audio format on the disc is not supported, it will be downmixed to
•[Off] – Disables audio output from the TV. The sound is only output through the speaker system.
[CD Upsampling]
Converts the music CD to a higher sampling rate using sophisticated digital signal processing for better sound quality.
•[Off] – Disables CD upsampling.
•[88.2kHz (X2)] – Converts the sampling rate of the CDs to twice as high as the original rate.
Note
•CD upsampling is only available in stereo mode.