Philips HTS3541 user manual 1 2 3, Play audio from home theater

Select [EasyLink] > [Audio Input Mapping], and then press OK.

Select [EasyLink] > [System Audio Control] > [On], and then press OK.

Select [Setup], and then press OK.

Press

(Home).

One-touch play

If you enable One-touch play, the TV automatically switches to the correct channel when you play a disc in your home theater.

One-touch standby

When you press and hold (Standby) on the remote control, the home theater and all the connected HDMI-CEC devices (that support one-touch standby) switch to the standby mode.

If one-touch standby is enabled on your home theater, you can switch to standby with the remote control of the TV or other HDMI- CEC devices.

System Audio Control

When you play a device that has its audio output routed to the home theater, the home theater switches to the corresponding audio source automatically.

To use one-touch audio, turn on System Audio Control and follow the instructions on the TV to map connected devices to the audio input connectors of the home theater.

Audio Input Mapping

When you connect a new device to your home theater, map the device to the audio input connector (see 'Play audio from home theater' on page 22).

Play audio from home theater

Play the audio from a connected device through your home theater.

5 Follow the instructions on the TV to map the audio of the connected device to the audio inputs on your home theater.

Note

•• If you connect your home theater to the TV through an HDMI ARC connection, make sure that the TV audio is mapped to the ARC input on your home theater.

1

2

3

4

• To play the audio from the TV speakers, select [Off], and skip the following steps.

EN 22