![Radio](/images/new-backgrounds/21213/2121357x1.webp)
3 Select a picture, and then press (Play) to start the slideshow.
4 Press to stop slideshow.
5 Press again to stop music.
Note
•• Make sure that the picture and audio formats are supported by your home theater (see 'File formats' on page 26).
Radio
Listen to FM radio on your home theater, and store up to 40 radio stations.
Note
•• AM and digital radio are not supported.
•• If no stereo signal is detected, or if fewer than five stations are found, you are prompted to install the radio stations again.
1 Extend the FM antenna at the back of your home theater and place it away from the TV or other sources of radiation.
2 Press RADIO.
»»If you have already installed the radio stations, the last channel that you listened to is played.
»»If you have not installed any radio stations, the message AUTO INSTALL...PRESS PLAY appears on the display panel. press (Play).
3 Use the remote control to listen or to change radio stations.
Button | Action |
/ | Select a preset radio station. |
or |
|
Alphanumeric |
|
buttons |
|
Navigation | Left/Right: Search for a radio | |
buttons | station. | |
|
| Up/Down: Fine tune a radio |
|
| frequency. |
|
| Press to stop the installation |
|
| |
|
| of radio stations. |
| BACK | Press and hold to erase the |
|
| preset radio station. |
OPTIONS Manual:
1)Press OPTIONS.
2)Press /
to select your preset. 3) Press
OPTIONS again to store the radio station.
Automatic: Press and hold for three seconds to reinstall the radio stations.
SUBTITLE Toggle between the stereo and mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning grid between 50 kHz and 100 kHz. Switching the tuning grid erases all preset radio stations.
1
2 Press .
3
MP3 player
Connect a MP3 player to play audio files.
What you need
•An MP3 player.
•A 3.5mm stereo audio cable.
1 Using the 3.5mm stereo audio cable, connect the MP3 player to the MUSIC iLINK connector on your home theater.
18EN