Front Panel
1 | 2 | 3 | 4 | 5 | 6 |
|
| 7 | 8 | 9 | |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
EN
1.Q(standby/on) button
•Press to turn on the unit, or to turn the unit into the standby mode. (To completely turn off the unit, you must unplug the AC power cord.)
•Press and hold for 10 seconds to shut down the unit.
•This button lights up in red when the unit is in standby mode and turns off when the power is on.
•Press to stop playback.
•Press to pause playback.
•Press to start or resume playback.
5.A (open/close) button
•Press to open or close the disc tray.
6.Disc tray
•Place a disc after opening the disc tray.
7.Display
•Refer to “Front Panel Display” on page 14.
8.Infrared sensor window
•Receive signals from your remote control so that you can control the unit from a distance.
9.SD card slot
•Insert an SD Memory Card and play back the contents in it.
Note
•Due to new ENERGY STAR® requirements, this unit will automatically enter standby mode after 25 minutes of inactivity.
Basic Connections Introduction
Rear Panel
1 | 2 | 3 | 4 | 5 |
Setup
|
|
|
|
| Y | PR/CR |
|
|
|
|
| L |
|
|
|
|
|
|
| PB/CB |
|
|
| COAXIAL |
| R |
|
Wireless LAN | HDMI OUT | LAN | AUDIO | VIDEO | COMPONENT | |
DIGITAL OUT | OUT | OUT | VIDEO OUT | |||
|
|
| PCM/BITSTREAM |
6 | 7 | 8 |
1.HDMI OUT jack
•Use to connect to a display with an HDMI compatible port with an HDMI cable.
2.LAN terminal
•Use to connect to network provisioning equipment such as a router or a modem with a LAN cable.
3.AUDIO OUT jacks
•Use to connect a TV monitor, an AV receiver / amplifier or other device with an RCA audio cable.
4.COMPONENT VIDEO OUT jacks
•Use to connect a TV monitor with component video inputs with an RCA component video cable.
5.AC power cord
•Connect to a standard AC outlet to supply power to this unit.
•Unplug this cord from the AC outlet to completely turn off the unit.
6.Wireless LAN (Internal)
7.DIGITAL OUT (COAXIAL) jack
•Use to connect an AV receiver / amplifier, Dolby Digital / DTS decoder or other device with a digital audio coaxial input jack with a digital audio coaxial cable.
8.VIDEO OUT jack
•Use to connect a TV monitor, an AV receiver / amplifier or other device with an RCA video cable.
•Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the unit.
•This unit does not have the RF modulator.
•Do not try to rip the internal Wireless LAN from the unit.
Others Setup Function Playback
EN 11