SETUPS

Network Connection

home

A “Settings” A

“Network Connection”

 

 

 

Set up network connection settings in order to use BD-Live,DLNA home media server, Netflix / CinemaNow / Blockbuster / VUDU or network upgrade function.

Connection Test

After you enable a network connection or change the network settings, always perform the connection test to check if the connection is correctly made.

1)Use [K / L] to select “Settings” in the home menu, then press [OK].

2)Use [K / L] to select “Network Connection”, then press [OK].

3)Use [K / L] to select “Connection Test”, then press [OK].

Connection test will start automatically and the test result will appear right after the connection test finishes.

•“Testing...” : The test is in progress.

•“Pass” : Connection test is successfully completed.

•“Fail” : Connection test failed. Check the connection settings.

If the connection test passes, press [OK].

•Confirmation screen of the network selection will appear. e.g.) Wired connection

Network Selection

Wired

 

 

 

 

 

 

 

then press 'OK'.

 

 

 

 

 

 

Press [OK] again to display the confirmation screen of network settings.

IP Address

xxx.xxx.xxx.xxx

Subnet Mask

xxx.xxx.xxx.xxx

Default Gateway

xxx.xxx.xxx.xxx

Primary DNS

xxx.xxx.xxx.xxx

Secondary DNS

xxx.xxx.xxx.xxx

 

then press 'OK'.

 

 

 

 

4)Press [OK] to go back to the previous screen, or press [ (home)] to go back to the home menu.

Note

•If the connection test passes, you are ready to use BD-Live,DLNA home media server, Netflix / CinemaNow / Blockbuster / VUDU or network upgrade function, using the Internet without making any additional settings.

•If the connection test fails, you may need to change the MAC address settings on your router. You can check the MAC address of this unit on “Network Status” screen (refer to page 60).

•When connecting this unit directly to a modem for the first time or connecting it to a modem which was previously connected to any other network device(e.g. a router, PC, etc.), you may have to power cycle the modem to reset the settings on the modem.

Wired Connection

Select “Wired Connection” if you made a wired connection and set the setting to “Standard”(wired) or “Manual”(wired), in accordance with your network environment.

Standard (Wired)

Network settings are set to the following settings initially. (In most cases, you can connect to the Internet without making any changes to the default settings.)

- IP Address Setting

Auto(DHCP)

- DNS Setting

Auto(DHCP)

- Proxy Setting

Do Not Use

- Connection Speed

Auto

- BD-Live Setting

Allow

If you want to set the network settings back to the default settings as above (except “BD-Live Setting”), follow the procedure below.

1)Follow steps 1) to 2) in “Connection Test” on page 57.

2)Use [K / L] to select “Network Selection”, then press [OK].

3)Use[K / L] to select “Wired Connection”, then press [OK].

4)Use [K / L] to select “Standard”, then press [OK].

•The unit will start the connection test automatically.

•If the connection test passes, press [OK] to go back to the home menu.

•If the connection test fails, press [OK] to go back to the previous screen. Please verify your settings and try again.

Note

•The setting of “BD-Live Setting” will not be set back to the default, even if you follow the procedure.

EN

Others Setup Function Playback Setup Basic Connections Introduction

EN 57